Connecting The Receiver To Other Equipment; Maintenance Of Emc Compliance - Cisco D9824 Installation And Configuration Manual

Chapter 2 Quick Setup - Read Me First!

Connecting the Receiver to Other Equipment

The following displays the rear panel of the D9824 Multi Decryption Receiver:
1 Connect the L-Band signal to RF1. 13V or 18V LNB power is only available on
the RF1 port. The factory default setting for LNB power is OFF.
2 Connect the ASI OUT port to an ASI device for digital tier applications.
3 Connect the Composite Video Output to a video monitor.
4 Connect the terminal block balanced audio outputs labeled AUDIO 1 and
AUDIO 2 to monitoring equipment.
5 Apply power by connecting the receiver to a power outlet. The message
"Application Starting" will appear on the front panel. The boot process
approximately 1 minute for the unit to initialize. When ready, the front panel
display shows the startup screen.
6 The Ethernet Management port supports the following network protocols:
Telnet, SSHv2, HTTP, HTTPS, SNMPv2, Syslog/DTX, SNTP, FTP (client side),
and TFTP.
7 Connect the ASI output (ASI OUT) to signal processing equipment or monitoring
equipment, if applicable.

Maintenance of EMC Compliance

The power cord (consisting of appliance coupler, flexible cord, and plug) supplied
with this product meets the requirements for use in the country for which this
product was purchased. In general, the power cord must be approved by an
acceptable, accredited agency responsible for evaluation in the country where the
product will be used.
Double-shielded (braid/foil or braid/braid) cables should be used for all ASI I/O
and RF inputs. Single-shield cables are acceptable for all other inputs and outputs.
For terminal block (Alarms) I/O, no shielding is required.
12