Cisco D9824 Installation And Configuration Manual page 152

Chapter 4 Front Panel Operation
Global
Menu Item
D/R Enable
D/R Profile
Signal Loss Timer
130
Description
Choose to enable or temporarily disable
the disaster recover feature. Choose Yes
(default) to enable disaster recovery.
Choose No to set the disaster recovery into
maintenance mode. It will automatically
set the Disaster Recovery back to Yes after
five minutes. This prevents the user from
accidentally disabling disaster recovery
permanently. To disable disaster recovery,
remove all the disaster recovery
configurations (Backup Channel and
Backup Transport settings).
The maintenance mode allows you to
perform any maintenance operations (such
as IP setup), without the unit declaring
disaster and initiating a disaster recovery
search path.
Note: Although the default is set to Yes,
the disaster recovery is not operational
until the search path is configured.
Select the disaster recovery setting to use.
Choose Local to use the disaster recovery
settings configured on the receiver, if the
PNC uplink is configured to allow local
disaster recovery.
Choose Uplink to use the PNC disaster
recovery profile. The PNC disaster
recovery profile is configured by the PNC
uplink administrator. For more
information, contact your PNC uplink
administrator.
Note: The PNC uplink determines whether
the local disaster recovery is used,
regardless of the D/R Profile setting. For
more information, see Disaster Recovery
(on page 7).
Select the time, in seconds, the unit must
wait (after detecting a signal loss) before
declaring a disaster. The default is 120
seconds.
Parameters
Yes or No
Local or Uplink
5 to 2160000 seconds