Step Configuration
4.
Deploy the access points and connect them to PoE switches.
5.
When the access points are operating, open the Discovery
Wizard to do the following:
1.
Specify the state of the access points, which is the factory
default state in a Layer 2 network.
2.
Run the Discovery Wizard.
3.
Select and add the access points that you want to be managed
by the wireless controller to the managed list.
Note:
By default, all access points are added to the basic group.
6.
Assign the access points to the access point profile groups (also
referred to as WLAN groups) Building 1 and Building 2.
ProSAFE Wireless Controller
System Planning and Deployment Scenarios
51
Web Management Interface Path
Access Point > Discovery Wizard
Configuration > WLAN Network