Change Access Point Information On The Managed Ap List - NETGEAR ProSAFE WC7500 User Manual

Change Access Point Information on the Managed AP List

For each individual access point, you can change the general information, IP settings, and
VLAN settings, you can switch between the internal and external antenna (if the access point
supports an external antenna), and you can enter location information.
For a WAC740 access point that is on the managed list, you can also enable link aggregation
by using the following procedure. Link aggregation is required if you want to set up a link
aggregation group (LAG) connection between the WAC740 access point and a switch.
For more information about setting up a LAG connection for a WAC740 access point, see
Enable Link Aggregation on a WAC740 Access Point
Note: Do not confuse link aggregation for a WAC740 access point with link
aggregation for a WC7600v1 or WC9500 wireless controller (see
Controller Link Aggregation Concepts
configuration between the WC7600v1 or WC9500 wireless controller
and a switch or router.

To change the information for an access point on the Managed AP List:
1. Open a web browser, and in the browser's address field, type the wireless controller's IP
address.
By default, the IP address is 192.168.0.250.
The wireless controller's login window opens.
2. Enter your user name and
page 170.
3. Click the Login button.
The wireless controller's web management interface opens and displays the Summary
page.
4. Select Access Point > Managed AP List.
The Managed AP List page displays.
5. Select the access point that you want to change by selecting its radio button in the Edit
column of the Managed AP List.
6. Click the Edit button.
ProSAFE Wireless Controller
on page 103), which is a
Change Access Point Information on the Managed AP List
Discover and Manage Access Points
170
on page 382.
on