Table of Contents
Advertisement
The previous figure shows the fields that display when you select the FTP radio button.
When you select the TFTP or Local File radio button, fewer fields are shown.
6.
Configure the settings as described in the following table.
Setting
TFTP, FTP, or Local File
Server Parameters section (TFTP and FTP only)
Server IP
File Name
User Name (FTP only)
ProSAFE Wireless Controller
Description
Select one of the following radio buttons to specify from which location the
upgrade must occur. The page adjusts to display the fields that are required for
each upgrade location.
•
TFTP. Upgrade from a TFTP server. The Server IP and File Name server
parameters fields display.
•
FTP. Upgrade from an FTP server. The Server IP, File Name, User Name,
and Password server parameters fields display.
•
Local File. Upgrade from a local file that you downloaded. The server
parameter fields do not display, but the Browse button becomes available.
To select the firmware upgrade file from your computer, follow the
directions of your browser.
Note:
If your WiFi controller runs a 3.x or 4.x firmware version and you want to
upgrade to a 5.x version, you must upgrade the firmware by using a TFTP or
FTP server. You cannot upgrade the firmware from a local file.
Enter the IP address of the TFTP or FTP server.
Enter the file name of the firmware.
Enter the user name to access the FTP server.
Maintain the Wireless Controller and Access Points
257
Hide quick links:
Advertisement
Table of Contents
