Supported Netgear Access Points - NETGEAR ProSAFE WC7500 User Manual

• WN370 ProSAFE Wall Mount Wireless N Access Point
• WND930 Outdoor Dual Band Wireless-N
• WNDAP660 ProSAFE Premium 3x3 Dual Band Concurrent Wireless-N Access Point
• WNDAP380R ProSAFE Dual Band Wireless-N Access Point with RFID support
• WNDAP360 ProSAFE Dual Band Wireless-N Access Point
• WNDAP350 ProSAFE Dual Band Wireless-N Access Point
• WNAP320 ProSAFE Wireless-N Access Point
• WNAP210v2 ProSAFE Wireless-N Access Point

Supported NETGEAR Access Points

You can connect access points to the wireless controller either directly with an Ethernet cable
through a router or switch, or remotely through a VPN network. After you use the automatic
discovery process and add access points to the managed access point list on the wireless
controller, the wireless controller converts the standard access points to dependent access
points by pushing firmware to the access points. From then on, you can centrally manage
and monitor the access points.
The following table lists the minimum firmware versions that must run on the standalone
access points before you convert them to managed access points. If your access point runs a
firmware version that is earlier than the minimum firmware version, first upgrade the access
point to the minimum firmware version or a later version.
Table 6. Minimum firmware versions
Access Point Model
WAC740
WAC730
WAC720
WN370
WND930
WNDAP660
WNDAP380R
WNDAP360
WNDAP350
WNAP320
WNAP210v2
ProSAFE Wireless Controller
Minimum Firmware Version on Standalone Access Point
Model WAC740 cannot function as a standalone access point. This model can be
used only as a controller-managed access point.
All firmware versions are supported.
All firmware versions are supported.
Model WN370 cannot function as a standalone access point. This model can be used
only as a controller-managed access point.
2.0.4 or a newer version is supported.
2.0.2 or a newer version is supported.
All firmware versions are supported.
2.1.6 or a newer version is supported.
2.1.7 or a newer version is supported.
2.1.1 or a newer version is supported.
All firmware versions are supported.
Hardware Descriptions
27