NETGEAR ProSAFE WC7500 User Manual page 325


To view the wireless controller Summary page:
1. Open a web browser, and in the browser's address field, type the wireless controller's IP
address.
By default, the IP address is 192.168.0.250.
The wireless controller's login window opens.
2. Enter your user name and password.
3. Click the Login button.
The wireless controller's web management interface opens and displays the Summary
page.
4. Select Monitor > Controller > Summary.
The following table describes the fields of the Network Status, Wireless Clients, Most
Active APs, Most Active Clients, and Most Active SSIDs tables of the page. The
Controller Info section is self-explanatory.
Note: If you configure redundant controllers, the page also displays
information about the status of the redundancy configuration. This
information is self-explanatory.
Item
Network Status
Total Up
Down
Alarms Critical
Major
ProSAFE Wireless Controller
Description
The total number of managed devices that are running correctly.
The total number of managed devices that cannot be pinged.
The wireless controller can ping these managed devices, but either cannot log in or
detected that these devices are different from the ones that were configured.
The number of managed devices for which the configuration differs from the one
that is set on the wireless controller. This situation occurs most likely because the
device runs outdated firmware or the wireless controller changed the configuration
while the device was down or offline.
Monitor the WiFi Network and Its Components
325