Table of Contents
Advertisement
c. Reconfigure the static IP address setting and the VLAN settings or reenable the
DHCP client.
For more information, see
Controller-Managed Access Point
a Controller-Managed Access Point
If you cannot connect to the access point, its IP address might be the factory default
IP address.
•
The access point's IP address is reset to the factory default IP address. Do the
following:
a. Determine the factory default IP address for the model access point.
Access Point Model
WAC740
WAC730
WAC720
WN370
WND930
WNDAP660
WNDAP620
WNDAP380R
WNDAP360
WNDAP350
WNAP320
WNAP210v2
1. The WNDAP380R does not provide a web
management interface and a default IP address.
The WNDAP380R can be managed only by a
wireless controller in a network with a DHCP server.
b. Configure a computer with a static IP address in the same subnet as the factory
default IP address of your model access point and a subnet mask of
255.255.255.0.
c. Use an Ethernet cable to connect the computer to the access point.
d. Log back in to the access point using the factory default IP address of your
model access point.
e. Enter the user name and password.
The user name is admin. The default password is password. The user name and
password are case-sensitive.
f. Select Configuration > Upgrade > Firmware Upgrade.
ProSAFE Wireless Controller
Change IP Address and VLAN Settings on a
on page 376 and
on page 377.
Factory Default IP Address
192.168.0.160
192.168.0.100
192.168.0.100
192.168.0.160
192.168.0.100
192.168.0.100
192.168.0.100
1
Not applicable
192.168.0.100
192.168.0.237
192.168.0.100
192.168.0.236
Controller-Managed Access Points
380
Reenable the DHCP Client on
Hide quick links:
Advertisement
Table of Contents
