Convert An Access Point From Controller-Managed To Standalone - NETGEAR ProSAFE WC7500 User Manual

Convert an Access Point From Controller-Managed to
Standalone
Note: You cannot convert a WAC740 or RN370 access point to a
standalone access point. The WAC740 and WN370 access points are
intended to function as controller-managed access points only.

To change a controller-managed access point to a standalone firmware version and
use the access point in standalone mode, do the following:
1. Remove the access point from the Managed AP List (see
the Managed AP List
2. Log in to the access point's limited web management interface, upgrade the firmware to the
standalone AP firmware version, (see
Controller-Managed Access Point
standalone access point.
ProSAFE Wireless Controller
on page 173.)
Upgrade or Change Firmware on a
on page 378), and reboot the access point as a
Controller-Managed Access Points
385
Remove Access Points From