Table of Contents
Advertisement
The following figure shows a close-up of the left side of the front panel.
Digital access point counter
LEDs (top to bottom):
Power, Status, Fan, Stack Master
Figure 2. Front panel close-up models WC7500 and WC7600v2
From left to right, the front panel of models WC7500 and WC7600v2 show the components
that are described in the following table.
Table 3. Front panel components models WC7500 and WC7600v2
Component
Digital counter
System LEDs
Ethernet ports and LEDs Four 10/100/1000 Mbps LAN Ethernet port with an RJ-45 connector, left LED, and
USB ports
SD card slot
Console port
Reset button
ProSAFE Wireless Controller
Description
Displays the number of connected access points that are in a healthy state.
From top to bottom: Power LED, Status LED, Fan LED, and Stack Master LED.
These LEDs are described in
right LED. The Ethernet port provides switched N-way, automatic speed negotiating,
auto MDI/MDIX technology.
Two USB 2.0 ports for external storage of floor heat maps, saving of the syslogs, and
backing up the configuration. The USB ports support FAT32 file systems.
An SD card for saving of the system logs will be supported in a future release.
RS232 port for connecting to an optional console terminal. The port provides a DB9
male connector. The default baud rate is 115200 bits/second.
Note:
The console port is for debugging under guidance of NETGEAR technical
support only.
Using a sharp object, press and hold this button for about 10 seconds until the Status
LED blinks and the wireless controller returns to factory default settings.
If you reset the wireless controller, all configuration settings are lost and the default
password is restored.
Hardware Descriptions
20
10/100/1000M RJ-45 ports
and LEDs
Table 5
on page 25.
USB ports
Hide quick links:
Advertisement
Table of Contents
