Table of Contents
Advertisement
Step Configuration
5.
When the access points are operating, open the Discovery
Wizard to do the following:
1.
Specify the state of the access points. The state can be either
factory default in a Layer 2 network or already installed and
functioning in standalone mode.
2.
Run the Discovery Wizard.
3.
Select the access points that you want the wireless controller to
manage and add them to the managed list.
Note:
By default, all access points are added to the basic group
and all settings from the basic group (profile definition, client
authentication, authentication settings, and WiFi QoS) are applied
to the access points.
Scenario Example 2: Advanced Network With VLANs and SSIDs
The following sample scenario consists of an advanced network with a wireless controller,
PoE switch, Layer 3 switch or router, access points, and several VLANs and SSIDs. The
wireless controller system includes the following VLANs:
•
VLAN 1, the default untagged VLAN to access the wireless controller
•
VLAN 10, a tagged client VLAN
•
VLAN 20, another tagged client VLAN
•
VLAN 100, a tagged management VLAN
Management VLAN 100 Ethernet traffic
Client VLAN 10 Ethernet traffic
Client VLAN 20 Ethernet traffic
Wireless controller
Backend L3 switch
or router
Internet
Figure 15. Example: Advanced network with VLANs and SSIDs
ProSAFE Wireless Controller
PoE switch
System Planning and Deployment Scenarios
46
Web Management Interface Path
Access Point > Discovery Wizard
SSID 1
Client VLAN 10
WNDAP360
WNDAP360
SSID 2
Client VLAN 20
Hide quick links:
Advertisement
Table of Contents
