Table of Contents
Advertisement
13.
To designate an access point as a remote access point, from the Site menu, select
Remote.
By default, all discovered access points are designated as Local. The Remote and Local
designations are for organization only.
Note:
The wireless controller cannot discover remote access points over a
site-to-site VPN connection or behind a remote NAT router without a
VPN connection. To use an access point as a remote access point over
a site-to-site VPN connection or behind a remote NAT router without a
VPN connection, you must preprovision the access point and send it to
the remote site for installation. For remote access points, the maximin
WAN delay period is 100 millisecond.
14.
Either select individual access points to be added to the managed list or select all access
points to be added to the managed list:
•
Select individual check boxes for discovered access points that you want to add to the
managed list.
•
Select the check box in the upper right of the table heading to add all discovered
access points to the managed list.
15.
Click the Add button.
Depending on the type of access points that were discovered, a page that lets you enter
or ignore a login name and a password might display.
16.
If necessary, enter the login name and password.
The Managed AP List page displays. Because this page is wide, it is shown in the
following two figures.
ProSAFE Wireless Controller
Discover and Manage Access Points
166
Hide quick links:
Advertisement
Table of Contents
