Toshiba GR200 Series Instruction Manual page 474

LED reset function (LEDR)
A number of LEDs are lined on the IED front panel. For example, "TRIP" LED is lit when a
tripping command is issued for the CB. "TRIP" LED is being illuminated until the user can
confirm the tripped CB; hence, the user can reliably determine that tripping CB has been
initiated by inspection. The following operations are possible to resetting the LED by the LED
reset (LEDR) function, which is furnished in the IED:
1
2
3
Note: For the operation, see Chapter
1
"CLEAR" key causes the Reset of the LEDs.
Note: For more information, see Chapter
2
─────────────────────────────────────────────────────────────────
Note: The implementation of particular features is dependent upon the selection of
hardware and the configuration of functions. Several IED models do not support certain
features. To determine whether a particular feature has been implemented within an IED,
identify the IED ordering number; and check the order number for the "G&T position" whilst
referring to the comparison table below. For more information, see
Table 3.6-1 Comparative table in respective ordering numbers
✓: Applicable
Pushing "CLEAR" key
Operation by GR-TIEMS
Operation by the SAS
Sec. Feature
– Main features
NA: Not applicable
1
2
User interface: Outline
Engineering tool.
Ordering No. at "G&T"
31
✓
- 453 -
6F2S1915 (0.46)
. Note that pressing the
Appendix: Ordering
32
✓
GRZ200 (Soft 031 & 032)
.