Toshiba GR200 Series Instruction Manual page 122

Hide thumbs Also See for GR200 Series:

ZG (Function ID： 431001）

Setting items

Z1XG-R.Angle

Z1XG-R.Reach

Z1XG-CovCoeff

for Reverse operation, it is necessary to set scheme switch [ZG-X.GrAngleEN]=Off.

value [ZGF-X.GrAngle1] will be calculated by itself. However, the user should set

a value be set for [ZGF-X.GrAngle2] regardless of the setting of scheme switch

[ZG-X.GrAngleEN

Off / On-Set / On-

0.00 - 100.00

On-Adapt is only applicable when Forward is set for ZG. If On-Adapt is set

When On-Adapt is set for scheme switch [ZG-X.GrAngleEN], the setting

- ZG gradient characteristic

deg Z1XG resistive reach characteristic angle

- Z1XG resistive reach

deg Z1XG directional-X characteristic angle

Z1XG directional-R characteristic angle (for

% Zero phase current factor, Self line R0/R1

% Zero phase current factor, Self line X0/X1

Zero phase current factor, Adjacent line

Zero phase current factor, Adjacent line

s Z1XG operation delay time

- Covered characteristic size coefficient

EFL operation condition used or not for Z1XG

Z1XG operation block or not in multi phase

- Z1XG operation block or not by PSB detection

- Load encroachment enable

- Z1XG leading phase operation block

Z1XG trip mode, phase segregated trip or 3-

- Autoreclose execution block by Z1XG-trip

- Fail-safe OC for Z1XG-trip

A Fail-safe OC operation level for Z1XG-trip

- SOTF using Z1XG

6F2S1915 (0.46)

GRZ200 (Soft 031 & 032)