Toshiba GR200 Series Instruction Manual page 851

Command blocking*1
Double Command Blocking detected*2
Other devices traveling detected*3
Function "Automatic sequence control" is in progress
ASEQ_MULTI_SEL
Tripping *4 ("General trip")
Additional condition (PLC connection point #1)
513001 800401EE65
TPOS01IN_TMP_33
User configurable condition (PLC connection point#2)
513001 810401EE66 TPOS01IN_TMP_34
Control hierarchy (e.g. 43RL) (PLC connection point#3) *10
513001 820401ED50 TPOS01IN_TMP_21
TPOS01IN_TMP_41
IED serious error detected
Figure 4.9-44 Operate condition logic for P1–3 control in TPOS01*
Note:
*1
blocking" is implemented as "CBK" in a software switch controller (SOFTSW);.
The IEC 61850 defines "Command Blocking" as "CmdBlk". For more information
of "CBK", see Chapter
control function
Note:
*2
to protect the substation. The user can program it using GR-TIEMS.
Note:
*3
changing the status of one or more devices. Thus, device operation by the IED
should be inhibited whilst ever the event is detected. The detection signal is
denoted as "Traveling OR" in Table 4.9-6.
Note:
*4
blocked until the trip operation has been completed. If the IED has a relay
application, the trip command is issued at the output-point "GEN.TRIP" in Table
TPOS01 function (Function ID: 513001)
CBK_STATE
DCB RCV OR
Unmatched condition detected *5
Traveling OR
Event suppression detected *6
= TPOS01_QLT_SPP
BI board connection error detected*7
GEN. TRIP
= TPOS01_QLT_BI_ERR
[SCDEN]*8
OFF
P1-control command received
(513001 8304011D02)
TPOS01_ST_P1
P2-control command received
(513001 8104011D03)
TPOS01_ST_P2
P3-control command received
(513001 8504011D04)
TPOS01_ST_P3
[TPOS01-DEVTYPE]*9
EDS
[TPOS01-LGSLFFCT]
Fixedlogic
Users must setup this condition correctly
SERI_ERR
[TPOS01-CTREN]
On
"Command Blocking" disables any operation except for itself; "Command
Control and monitoring application: Software switch
. See the signal "CBK_STATE" in Table 4.9-6.
"Double Command Blocking (DCB)" is an operation philosophy. It can be used
Detection of event "device-travelling signifies that other operators are
If an IED is in the process of issuing a trip command, all control operation is
1≥
(513001 8204011F59)
(513001 8604011F5A)
&
&
&
&
&
- 830 -
6F2S1915 (0.46)
1≥ &
&
To selection logic
Operate condition
Same Directional
Controlling Event
"EDS" never permit to control
from "P1 to P3" and "P3 to P1".
&
&
11
GRZ200 (Soft 031 & 032)