Toshiba GR200 Series Instruction Manual page 682

Total time measurement function (TOTALTIM)
The total time measurement function (TOTALTIM) can measure 'operating time' (i.e., a device-
running-time, closing-time, switching-ON-time, etc.) with a binary signal which may be
collected in the binary input circuits. The TOTALTIM function can keep the operation time in
the memory; the user can recognize it as a statistics data (for more information, see Chapter
Monitoring function: Statistics data
time (i.e., TTIM01 to TTIM12). For simplicity, the TTIM01 is only discussed but the other
schemes are identical to the TTIM01 scheme.
─────────────────────────────────────────────────────────────────
Note: The implementation of particular features is dependent upon the selection of
hardware and the configuration of functions. Several IED models do not support certain
features. To determine whether a particular feature has been implemented within an IED,
identify the IED ordering number; and check the order number for the "G&T position" whilst
referring to the comparison table below. For more information, see
Table 4.5-1 Comparative table in respective ordering numbers
✓: Applicable
). The TOTALTIM function can operate 12 schemes at same
Sec. Feature
– Main features
– Number of functions
NA: Not applicable
- 661 -
Ordering No. at "G&T"
31 32
NA
✓
NA 12
6F2S1915 (0.46)
Appendix: Ordering
.
GRZ200 (Soft 031 & 032)