Toshiba GR200 Series Instruction Manual page 852

4.9-6.
Note:
*5
command is not identical to "IED test status".
Note:
*6
4.9.6(i)-3)
Note:
*7
circuits
Note:
*8
– direction of logic. When the user sets off for scheme switch [SCDEN], operation
of the logic is blocked if the logic is running in the same operation-direction
compared with the previous operation-direction. Alternatively, if On is set for the
scheme switch, the logic is not blocked.
Note:
*9
switch(ES) is applied for the TPOS01 function.
Note:
*10
user must connect the "Control hierarchy" condition to the select condition logic
using the connection point TPOS01IN_TMP_21" for more information, see chapter
Control and monitoring application: Control hierarchy
Note:
*11
#3. Note that the logic outputs are generated separately for P1, P2 and P3-
control.
Signal name and number
(xi)
Note: The user should note the meaning of the following abbreviations as shown in
column "M/O" of each table:
"O" signifies that the signal is provided for the optional use.
"M" signifies that the user should map/set/configure the signal; otherwise, the
"N/A" signifies that the user cannot change the state of the signal.
Table 4.9-15 PLC connection points (Input signal PLC#1 user a configurable condition)
Signal Number Signal Name
513001 800401EE56 TPOS01IN_TMP_27
513001 800402EE56 TPOS02IN_TMP_27
513001 800403EE56 TPOS03IN_TMP_27
... ...
513001 800418EE56 TPOS24IN_TMP_27
Table 4.9-16 PLC connection points (Input signal PLC#2 user configurable condition)
Signal Number Signal Name
513001 820401EE5E TPOS01IN_TMP_38
The criteria "unmatched conditions" is determined when "Test-bit status" in a
The Function "Event suppression" can detect chattering in BI circuits. (See
A supervision of the Binary IO module can detect connection errors for BI
.
The "Common control" (CMNCTRL) function can test or check the operation
The user should set scheme switch [TPOS01-DEVTYPE] EDS when the earth-
The user must program the PLC logic for "Control hierarchy condition" The
To identify the input points of the other TPOS, see Table 4.9-8 for PLC#1 to
user may experience an operational failure if the default settings is used.
Description
TPOS01 operate condition configured by the user (for PLC#1)
TPOS02 operate condition configured by the user (for PLC#1)
TPOS03 operate condition configured by the user (for PLC#1)
...
TPOS24 operate condition configured by the user (for PLC#1)
Description
TPOS01 operate condition configured by the user (for PLC#2)
- 831 -
6F2S1915 (0.46)
" see PLC#3 of Table 4.9-8.
GRZ200 (Soft 031 & 032)
M/O
O
O
O
O
M/O
O