Toshiba GR200 Series Instruction Manual page 732

Table 4.7-8 Signals generated in control functions
Control Device status generated by the control
function function described on the left column
SPOS
DPOS
"device status" except "0x40" and "0x80"
TPOS
"device status" except "0x01", "0x02" and
BI
signal
†Note: Values are altered when "AND", "OR", or "NOT" is applied as an interlock
operator.
‡Note: Values are altered when "COMP" is applied as an interlock operator.
§Note: Values are altered when the DPOS output is an inverted signal.
Configuration of Interlock formulae
4.7.4
Interlock-check formulae should be stored in the Interlock database, as shown in Figure 4.7-1.
These formulae are configured using GR-TIEMS†, and are uploaded into the ILK interlock
database.
†Note: The configuration of interlock-check formulae is discussed separately. See chapter
Engineering tool: Interlock configurator
0(off)
1(on)
0x40(Open)
0x80(Close)
0x01(P1)
0x02(P2)
0x04(P3)
"0x04"
0(off)
- 711 -
"stVal" transposed in the node
0
1
0† 0x40‡
1† 0x80‡
0
1
2
4
0
0
.
6F2S1915 (0.46)
1§
0§
GRZ200 (Soft 031 & 032)