Siemens SINUMERIK 840D sl Commissioning Manual page 513

$TC_CARR37[n]
Decimal place
ONE MILLION TEN
MILLION
HUNDRED MILLION
Retracting the geometry axes before swiveling
The type of retraction is modified in the manufacturer cycle CUST_800.SPF.
For further information on this, see Chapter Manufacturer cycle CUST_800.SPF (Page 518)
Note
When traversing the tool axes, the following must be taken into account:
Retract the tool axis in such a way that the tool and workpiece cannot collide when swiveled.
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Display variants of the input screens for CYCLE800
Meaning
Selection field, retraction
00 = No retraction
01 = Retraction Z
02 = Retraction Z, XY
03 = Retraction Z or Z, XY
04 = Maximum retraction in tool direction
...
08 = Incremental retraction in tool direction
...
15 = Retraction Z or Z, XY or
in maximum tool direction or in incremental tool direction
$TC_CARR38[n]
$TC_CARR39[n]
$TC_CARR40[n]
Swivel data set enabled
Setting swivel data set change
Automatic or manual tool change is only required for ShopMill or ShopTurn (→ See also:
CUST_800.spf, markers _M2 to _M13).
A swivel data set must be "enabled" in each case (value ≥ 4).
0 = Swivel data set not enabled
4 = Swivel data set enabled
automatic swivel data set and tool change
5 = Swivel data set enabled
automatic swivel data set change and manual tool change
6 = Swivel data set enabled
manual swivel data set change and automatic tool change
7 = Swivel data set enabled
manual swivel data set and tool change
Retraction position X
Retraction position Y
Retraction position Z
Configuring cycles
22.6 Swiveling
507