Face End Machining (Transmit) Under Shopturn - Siemens SINUMERIK 840D sl Commissioning Manual

Setting up
In addition, set the following channel-specific configuration machine data:
MD52214 $MCS_FUNCTION_MASK_MILL
Bit 3
Bit 4
References
Additional information on cylinder surface transformation is provided in:
840D sl Programming Manual Job Planning: Cylinder surface transformation
22.10.5

Face end machining (TRANSMIT) under ShopTurn

Function
If you wish to use the end face machining function under ShopTurn, please proceed as
described in Chapter End face machining (TRANSMIT) (Page 485).
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Enable "internal / rear" machining in ShopTurn masks (screens) that define the
machining plane themselves.
If you have implemented the "Clamp/release spindle" function using the machine
manufacturer cycle CUST_TECHCYC.SPF, then using this machine data, you can
activate the "Clamp/release spindle" parameter in the drilling and milling screens.
= 0 The "Clamp/release spindle" parameter is not displayed in the drilling and milling
screens.
ShopTurn automatically clamps the spindle if it makes sense for the particular
machining operation.
= 1 The "Clamp/release spindle" parameter is displayed in the drilling and milling screens.
The operator decides for which machining operation the spindle should be clamped.
Software option
You require the following software option in order to use this function:
"Transmit and peripheral surface transformation"
22.10 Turning with ShopTurn
Milling function masks (screens).
Configuring cycles
575