Siemens SINUMERIK 840D sl Commissioning Manual page 460

Configuring cycles
22.1 Activating turning/milling/drilling technologies
Additional settings
MD52201 $MCS_TECHNOLOGY_EXTENSION
= 1
= 2
MD52005 $MCS_DISP_PLANE_MILL
= 0
= 17
= 18
= 19
MD52006 $MCS_DISP_PLANE_TURN
= 18
MD52212 $MCS_FUNCTION_MASK_TECH
Bit 0
Bit 1
Bit 5
MD52240 $MCS_NAME_TOOL_CHANGE_PROG
= Program name
See also
Technology cycles for swiveling (Page 491)
454
Additional settings for turning
Additional settings for turning,
e.g. lathe with milling technology
MD52200 $MCS_TECHNOLOGY = 1
MD52201 $MCS_TECHNOLOGY_EXTENSION = 2
Milling: Plane selection in the cycle support when programming under "programGUIDE G
code"
G17 plane (default value)
G18 plane
G19 plane
G18 plane (permanently set)
Enable swivel
= 0 Swivel plane, swivel tool not enabled
= 1 Swivel plane, swivel tool enabled
No optimized travel along software limit switches
= 0 No optimized travel along software limit switches
= 1 Optimized travel along software limit switches
The cycle for SERUPRO (CYCLE207) is called in the block search cycle
PROG_EVENT.SPF
The associated program is called for tool change.
Technology extension for combined
machines with several technologies
Plane selection G17, G18, G19
Plane selection G17, G18, G19
Cross-technology function mask
Tool change program for G code steps
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)