Technology Cycles For Drilling - Siemens SINUMERIK 840D sl Commissioning Manual

22.2

Technology cycles for drilling

Drilling technology
You can set drilling technology using the following channel-specific configuration machine
data and channel-specific cycle setting data.
MD52216 $MCS_FUNCTION_MASK_DRILL
Bit 0
Bit 1
SD55216 $SCS_FUNCTION_MASK_DRILL_SET
Bit 1
Bit 2
Bit 3
Bit 4
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Tapping cycle CYCLE84, technology input fields
= 0 Hide input fields
= 1 Display input fields
Tapping cycle CYCLE840, technology input fields
= 0 Hide input fields
= 1 Display input fields
Boring CYCLE86: Take into account the rotation of the tool plane when positioning the
spindle
Note:
Spindle direction of rotation M3/ M4 and direction of rotation of the rotary axes must be set
according to DIN. For SPOS=0, the tool cutting edge points in the + direction of the 1st
axis of the plane (for G17, to X+).
= 0 Do not take into account the rotation of the tool plane when positioning the spindle
(SPOS).
= 1 Take into account the rotation of the tool plane when positioning the spindle (SPOS).
Boring CYCLE86: When positioning the spindle, take into account swiveled table
kinematics (tool carrier)
= 0 When positioning the spindle, do not take into account the components of the swiveled
table kinematics (swiveling with CYCLE800, tool carrier).
Note:
Only the rotary axis of the machine kinematics that rotates the workpiece is taken into
account. In the initial state of the kinematics, this rotary axis must be orientated parallel to
the tool axis.
e.g. rotary axis C rotation around Z (for G17) rotary axis vector of the swivel data set
V2xyz = 0 , 0 , -1.
= 1 When positioning the spindle, take into account the components of the swiveled table
kinematics (swiveling with CYCLE800, tool carrier).
Tapping CYCLE84: Monitoring of the machine data
MD31050 $MA_DRIVE_AX_RATIO_DENOM and
MD31060 $MA_DRIVE_AX_RATIO_NUMERA of the spindle
Tapping CYCLE84, set monitoring of the machine data
MD31050 $MA_DRIVE_AX_RATIO_DENOM and
MD31060 $MA_DRIVE_AX_RATIO_NUMERA of the spindle
= 0 No monitoring
= 1 Monitoring
Configuring cycles
22.2 Technology cycles for drilling
Drilling function mask
Drilling function mask
455