Siemens SINUMERIK 840D sl Commissioning Manual page 874

Service and diagnostics
3.4 Backing up data via the service shell
3.4.4 This is how you restore data from the network drive
Sequence
Proceed as follows:
● Connect the service system.
● "Service Shell" open.
● Establish a connection to a network drive.
● Restore the data.
Scenario : Start command shell under Linux
I
1. Connect the service system to the USB interface X125 or X135 of the NCU.
2. In the main menu, select the menu item "Service Shell".
3. Log on as a service technician using the user name "manufact" and password
4. Use the command "sc connect" to connect the network drive:
5. Please enter here the user name and the password for the network drive that is to be
6. To restore user data only, enter the following command:
Scenario : Start the command shell with WinSCP on the programming device:
II
Procedure:
1. Start WinSCP and enter the following data in the log-on window:
2. Select in the menu "Commands" → "Open Terminal".
3. To restore the data, enter the corresponding commands as described under steps 3 to 5
78
"SUNRISE".
sc connect //username%password@server/share /tmp/backup
connected to.
To completely restore the system (system data and user data), enter the following:
restore –full backup01
Result: The whole system is overwritten by the backup data.
sc restore –user backup01
Result: The user data are written back again.
All subsystems are then restarted:
Result:
The system state stored in the file "backup01.tgz" is restored on the NCU.
– IP address of the NCU (or, if required, host name)
– User name "manufact" with password "SUNRISE".
in scenario .
I
sc start all
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
sc
NCU operating system (IM7)