Siemens SINUMERIK 840D sl Commissioning Manual page 327

Parking axis
Displays (yes/no) whether it is a parking axis/spindle.
Note
With parking axes/spindles, all encoder-specific monitoring and evaluation functions are
switched off. This allows the encoder to be withdrawn without initiating an alarm.
Specified drive data set
The display (default: DDS0) of which of the eight drive parameter sets is to be activated by
the PLC corresponds to the interface signal:
DB31, ... DBX21.0 to 21.2 "Drive parameter set selection A, B, C".
More detailed information on working with the drive and motor data sets can be found in:
Commissioning Manual, IBN CNC: NCK, PLC, Drive
Actual drive data set
The display (default: DDS0) of which of the eight drive parameter sets is currently active
corresponds to the interface signal:
DB31, ... DBX93.0 to 93.2 "Active drive parameter set A, B, C".
Specified motor data set
The display (MDS0...3) of which motor data set is to be activated by the PLC corresponds to
the interface signal:
DB31, ... DBX21.3 to 21.4 "Motor selection A, B".
The following assignment applies:
Motor data set
MDS0
MDS1
MDS2
MDS3
Actual motor data set
The display (MDS0...3) of which motor data set is currently active corresponds to the
interface signal:
DB31, ... DBX93.3 to 93.4 "Active motor A, B".
Operating mode
The display of the control type of a drive corresponds to the drive parameter:
p1300[0...n] "Open-loop/closed-loop control mode".
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Coding
0
0
1
1
Service and diagnostics
18.2 Displaying the Service overview
0
1
0
1
321