Extending The Prog_Event Standard Cycle - Siemens SINUMERIK 840D sl Commissioning Manual

Configuring cycles
22.3 Manufacturer cycles
Note
When upgrading the software, please refer to the upgrade instructions.
22.3.2

Extending the PROG_EVENT standard cycle

If you wish to extend the functionality of the PROG_EVENT, then you must not copy this into
the manufacturer cycles directory, but you must create two new manufacturer cycles. Use
the names CYCPE1MA.SPF or CYCPE_MA.SPF names for the manufacturer cycles.
For the manufacturer cycles CYCPE1MA.SPF or CYCPE_MA.SPF, the corresponding
jump markers are prepared at the beginning and at the end of PROG_EVENT.SPF.
If the CYCPE1MA.SPF and CYCPE_MA.SPF manufacturer cycles are created in the NC, the
program correspondingly branches from PROG_EVENT to the manufacturer cycles.
Procedure
458
4. Press the "Copy" softkey and open the NC data/Cycles/Manufacturer
cycles directory.
5. Press the "Paste" softkey.
The cycles are available for you to individually adapt them.
1. Select the "Start-up" operating area.
2. Press the "System data" softkey.
3. Select the directory /NC data/Cycles/Manufacturer cycles
4. Press the "New" softkey.
The "New G Code Program" window opens.
5. Assign the name CYCPE1MA or CYCPE_MA.
Only use these names.
6 Press the "OK" softkey.
The cycle has been created and you can now adapt it.
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)