Siemens SINUMERIK 840D sl Commissioning Manual page 627

Getting Started
2.1 Introduction
Using the following example, you get to know the steps necessary to insert your own dialogs
into the SINUMERIK Operate user interface using Run MySreens. You also learn how to
create your own dialogs, insert context-sensitive help screens and help calls, define softkeys
and how you can navigate between the dialogs.
Note
When using HMI Operate in the NCU, note that all file names are written in lower case letters
(com, png, txt) on the CF card. This is required because of Linux.
On the PCU, you can write file names either in upper case or lower case letters.
2.2 Example
2.2.1 Task description
Dialogs
You will create two dialogs in the example. R parameters that can be written to (0 and 1) and
geometry axis names (input fields) are displayed in the first dialog. The corresponding help
screens are linked in for the two R parameters. A context-sensitive help is linked in for the
geometry axes.
Dialog 1: Display of R parameters and channel MD
Figure 2-1
SINUMERIK Integrate Run MyScreens (BE2)
Programming Manual, 03/2013, 6FC5397-1DP40-3BA1
Dialog 1: R parameters with context-sensitive help screens
2
9