Siemens SINUMERIK 840D sl Commissioning Manual page 144

Tool management
12.2 Configuring the user interface
Entries
ShowSymbolActiveTool
ShowSymbolProgrammedTool
ShowSymbolActiveDNo
ShowSymbolActiveDNoInTool
ShowSymbolAcitveDlNo
ShowConflictPositionAndDirection
ShowConflictActiveToolWarning
ShowSymbolActiveIsoHNoL1
ShowSymbolActiveIsoHNoL2
ShowSymbolActiveIsoHNoL3
ShowSymbolActiveIsoDNo
ShowSymbolActiveIsoHDNo
Example
<SETTINGS>
</SETTINGS>
138
<ReactivateWithMagPos value="false" type="bool" />
<MagazineMoveMessage value="false" type="bool" />
<CreateNewToolDialog value="true" type="bool" />
<MagazineSelectionDialog value="false" type="bool" />
<AccessLevelWriteDetailsAllParameter value="4" type="int" />
Meaning
Marking of the active tool.
False - default setting.
Marking of the follow-on tool.
True - default setting.
Marking of the active cutting edge.
False - default setting.
Marking of the active tool by marking the active cutting
edge.
True - default setting for configuration without magazine
management.
False - setting for configuration with magazine
management.
Marking of the active DL number.
True - default setting.
Marking of a conflict; tool position and cutting direction do
not match.
True - default setting.
Marking of a conflict; revolver magazine type and the active
tool are not at the the machining position.
True - default setting.
Marking of the active H number for length 1 in the ISO tool
list.
true: Default setting.
Marking of the active H number for length 2 in the ISO tool
list.
True - default setting.
Marking of the active H number for length 3 in the ISO tool
list.
True - default setting.
Marking of the active D number in the ISO tool list.
True - default setting.
Marking of the active HD number in the ISO tool list.
True - default setting.
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)