Siemens SINUMERIK 840D sl Commissioning Manual page 171

</NEWTOOLDEFAULTVALUECONFIGURATION>
Default values when creating new tools
System variables
Tool size
Size on left
Size on right
Size above
Size below
Magazine location type of the tool
Created outside of the magazine
Created in a magazine location
Tool status
released
The following combinations between the cutting-edge position and the cutting direction result
dependent on the tool type. When creating the new tool, the operator selects a combination
in the "New Tool - Favorites" window.
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
<CUTTEDGEPOS_3>
<Default value="93.0" type="double" />
</CUTTEDGEPOS_3>
<CUTTEDGEPOS_4>
<Default value="93.0" type="double" />
</CUTTEDGEPOS_4>
<CUTTEDGEPOS_5>
<Default value="49.0" type="double" />
</CUTTEDGEPOS_5>
<CUTTEDGEPOS_6>
<Default value="49.0" type="double" />
</CUTTEDGEPOS_6>
<CUTTEDGEPOS_7>
<Default value="49.0" type="double" />
</CUTTEDGEPOS_7>
<CUTTEDGEPOS_8>
<Default value="49.0" type="double" />
</CUTTEDGEPOS_8>
</HolderAngle>
</TOOLTYPE_500>
<!-- Initialize coolant 2 of the plunge cutter to switched on -->
<TOOLTYPE_520>
<Coolant2>
<Default value="true" type="bool" />
</Coolant2>
</TOOLTYPE_520>
12.2 Configuring the user interface
Default value
$TC_TP3 1
$TC_TP4 1
$TC_TP5 1
$TC_TP6 1
$TC_TP7 1
$TC_TP7 Location type of the magazine location
$TC_TP8 2
Tool management
165