Mitsubishi Electric MELSEC iQ-R Series User Manual page 290

*1 The setting is applied when '1: supported' is stored in 'PTZ speed support' (Un\G34236).
When '0: not supported' is stored in 'PTZ speed support,' a set value is ignored.
*2 A value stored in this area is converted to a relative value in the range of -1000 to 1000 for an actual position (coordinate) captured by a
network camera.
*3 A value stored in this area is converted to a relative value in the range of 0 to 1000 for an actual position (coordinate) captured by a
network camera.
■PTZ operation processing requestor (Un\G38001)
The request source for PTZ operation processing to a camera recorder module is stored.
Value
0H (not requested)
1H (tool)
2H (GOT)
3H (ladder program)
■PTZ operation status (Un\G38002)
The current PTZ operation status is stored.
Value
0H (not requested)
1H (PTZ control being
performed)
2H (PTZ control completed
successfully)
3H (preset position being
registered)
4H (preset position registered
successfully)
5H (preset position being
deleted)
6H (preset position deleted
successfully)
7H (preset request being
executed)
8H (preset request completed
successfully)
FFFFH (error completion)
7 CAMERA RECORDER MODULE (DETAILED SPECIFICATIONS)
288
7.4 Buffer Memory
Description
PTZ operation is not requested.
A PTZ operation request was sent from a tool.
A PTZ operation request was sent from a GOT.
A PTZ operation request was sent from a program.
Description
PTZ operation is not requested.
PTZ control is being performed on a network camera in a direction specified in a camera recorder module.
PTZ control is completed for a network camera in a direction specified in a camera recorder module.
A preset position is being registered in the flash memory of a camera recorder module.
Registering a preset position in the flash memory of a camera recorder module is completed.
A preset position registered in the flash memory of a camera recorder module is being deleted.
Deleting a preset position registered in the flash memory of a camera recorder module is completed.
PTZ control is being performed on a network camera for a preset position specified in a camera recorder module.
PTZ control is completed for a network camera for a preset position specified in a camera recorder module.
An error occurred in PTZ operation.