Mitsubishi Electric MELSEC iQ-R Series User Manual page 148

Item
Recording Files Saving Information
*1 For the conditions under which data is cleared, refer to the following:
Page 221 Recording status area (Un\G1500 to 3199)
*2 For the conditions under which data is cleared, refer to the following:
Page 228 Recording buffer batch saving mode (Un\G4001)
*3 A NULL character is used as a termination character, and characters out of the specification range before the termination character are
replaced with periods (.) and displayed.
For available characters, refer to the following:
Page 294 ASCII characters that can be used in the format in the saving detail setting
*4 For the conditions under which data is cleared, refer to the following:
Page 229 File server saving information area (Un\G9000 to 10999)
4 RECORDING MONITOR
146
4.1 Recording Status Detailed Information Screen
*1
Accumulated Data
*2
Batch Saving
*1*3
Path Saved at Last
*4
File Server Saving Path
Description
When data accumulation is performed once, "Data Exists" is stored.
When using a recording startup trigger, data is not accumulated before the
trigger is satisfied.
Depending on the timings of data accumulation and a recording startup
trigger, accumulated data may not be included in a saving period and may not
be saved to a recording file.
Whether the recording buffer batch saving mode is enabled is stored.
(Page 62 Recording buffer batch saving mode)
• OFF: Disabled
• ON: Enabled
The mode can be switched by right-clicking the cell and selecting [ON] or
[OFF].
The path to a last saved recording file is stored.
(Example) 1TS01_001
When specifying a file server as the save destination, the path to a folder that
saves a recording file is stored.