Canon CXDI-31 Service Manual page 89

Examples of parameters used with different makers and types of printers (reference)
• Kodak MLP190
-A 320 -T NO -M CUBIC –m NORMAL -S CS000
(entered in param member)
80 (entered in pixelPitch member)
14 x 17
4096 (entered in W member)
5120 (entered in H member)
• Trimming OFF
• Cubic spline interpolation
• Smoothing: normal
• Maximum density: 3.20
• Curve shape 0 (density linear) as Config Info
• Kodak KELP2180 + Kodak Print Spooler Model 100
-A 320 -T NO -M CUBIC –m NORMAL -S CS000
(entered in param member)
79 (entered in pixelPitch member)
14 x 17
4090 (entered in W member)
5120 (entered in H member)
11 x 14
3194 (entered in W member)
4096 (entered in H member)
• Trimming OFF
• Cubic spline interpolation
• Smoothing: normal
• Maximum density: 3.20
• Curve shape 0 (density linear) as Config Info
• Agfa DryStar 3000
-A 320 -T NO -M CUBIC -m 140 -S "PERCEPTION_LUT=200"
(entered in param member)
80 (entered in pixelPitch member)
14x17
4256 (entered in W member)
5174 (entered in H member)
• Trimming OFF
• Cubic spline interpolation
• Smoothing: slightly sharp (edges emphasized)
• Maximum density: 3.20
• S "PERCEPTION_LUT=LINEAR" (If the output fails to be linear with "LINEAR", on-
site adjustments with the printer manufacturer must be performed.
2 Installation Manual
- 63 -