Canon CXDI-31 Service Manual page 50

12) When a DP file is created, "defPat process success." and "Make Bitmap image of
defect pattern?[y]:" are displayed. Enter "n".
13) You will go back to the "CCR IP DEBUG CALIBRATION PROCESS MENU".
Select "20. Edit Text Info. In Defpix File".
14) The message below appears. From 0 to 3, select the serial number of the sensor for
which you want to correct the DP file.
A/D Board No. 0-0 Serial No. ********
A/D Board No. 0-1 Serial No. ********
A/D Board No. 0-2 Serial No. ********
A/D Board No. 0-3 Serial No. ********
Select Defect Pixel File ([0-3]: AD No. Other :Specify)[0= 0x0]:
15) The message below appears. Carefully select as follows because proper image
correction is not performed if you mistake the selection.
DP file for CXDI-31 ......... Enter "2". (Seamless correction not required)
DP file for CXDI-11, 22 ..... Enter "1". (Seamless correction required)
######## Seamless-Type Part Edit ########
Edit (1) or Clear (2) Info. [1=0x1]:
* Only when you enter "1", "Select Seamless Type 0:No 3:Type3 100:TypeH[3=0x3];" is
displayed. Enter "2". (Seamless correction required)
16) The message below appears. Enter "2".
######## Sensitivity-Correction Part Edit ########
Edit (1) or Clear (2) Info. [1=0x1]:
17) "Do you want to save this command? (N:0, Y:1) [1=0x1]" is displayed. Enter "1".
18) "save defect pattern files Path [********.dp]:" appears. Enter the DP file to which the
correction data is to be written. Usually the file name is overwritten and you do not have
to enter the name.
19) "save success." is displayed. You will go back to the "CCR IP DEBUG
CALIBRATION PROCESS MENU". Move to "Welcome to CCR" menu and select "8.
Exit" to close the CXDI application.
2 Installation Manual
- 24 -