Canon CXDI-31 Service Manual page 78

Parameter List (Separate Document 1)
DICOM storage device
In the CXDI, DICOM data transfer is performed using the transfer software module
"send_image" .The settings for these parameters are described below.
(1) -m maxPDU
(2) -t calledTitle
(3) -c callingtitle
(4) -s SOPName
(5) -I
(6) -d FAC
(7) –v
(8) -jn
(9) –k
(1) -m maxPDU
-m maxPDU
Maximum PDU value in byte units
Meaning * The CXDI automatically uses 131072 internally for operation.
* Designating a specific value allows overwriting of the above value.
Description * The DICOM standards do not allow values of 1301073 or higher to be set.
* This is used when the operator of the connected storage device requests a size
change.
* In DICOM printing, note that the argument title changes to -u.
( See the printing parameters.)
(2) -t calledTitle
-t calledTitle
Called App Entity Title
Meaning * The AE Title setting field is automatically applied to this setting.
* Designating a specific value allows overwriting of the above value.
Description * Note that the meaning is opposite of the DICOM printing argument -c.
( See the printing parameters.)
* This is used when the operator of the connected storage device requests a
change in the installed
identification information (version).
(3) -c callingtitle
-c callingtitle
calling App Entity Title
Meaning * The CXDI automatically uses CANON_CCR internally for the operation.
* Designating a specific value allows overwriting of the above value.
Description * Note that the meaning is opposite of the DICOM printing argument -c.
( See the printing parameters.)
* This is used when the operator of the connected storage device requests a
change in the installed
identification information (version).
(4) -s SOPName
-s SOPName
(for reference)
This parameter designates the class used for connecting the association at the start of the
transfer.(CR/T/MR/NM/SC/US)
Meaning * This is not used in the CXDI.
Description
2 Installation Manual
- 52 -