Replacing The Sensor Cable; Replacing The New Sensor Cable(Bg7-3055) - Canon CXDI-31 Service Manual

3.2.2. Replacing the sensor cable

3.2.2.1.

Replacing the new sensor cable(BG7-3055)

Follow the instructions below to replace the new sensor cable (BG7-3055).
(1) Remove the rear cover by following the steps in "3.2.1 How to replace with the sensor
cable without cable clamp".
Note:
When replacing the rear cover, be careful not to touch the internal TAB. For details, refer
to "3.1.1 Notes on the tabs exposed on the internal sensor" in the section 3.1 "Notes".
(2) Raise the insulating sheet shown in [Fig.2] to front to make the cable connection visible.
3. CXDI-31 Imaging Unit
Sensor cable (BG7-3055)
[Fig.1]
[Fig 2]
- 14 -
Insulating
sheet