Canon CXDI-31 Service Manual page 5

The size and supplementary number 000 marking is omitted.
The size number is given into ( ) below the part number for only adjustment parts.
The parts whose part numbers are listed together and enclosed in ( ) are adjustment parts,
C. Q'ty Column
The number of units of parts used in the mechanism are indicated.
The marking is N for those adjustment parts which are not used in uniform quantities.
The marking is 1 for those parts whose length is not specified in the part number. Their length by
standard specified is given in ( ) below the part number in the PARTS NO. column.
5.3 Circuit Diagram
Electrical repair parts which are difficult to be showed in disassembly diagrams are illustrated.
5.4 Part Number Index
Except for the standard parts all the repair parts showed in disassembly and circuit diagrams are
listed in the order of the part number.
The page where the part is listed is found by referring its part number.
REVISION NO. – REPORT NO. Column
Informed of an advanced revision number by the Service Manual Report, the customer enters the
new revision number and the report number in this column.
A. REVISION NO.-REPORT NO Column
Informed of an advanced revision number by the Service Manual Report, the customer enters
the new revision and the report number in this column.
Example ... BA03415-000 ...
020 : t= 0.2mm
050 : t= 0.5mm
100 : t =1.0mm
Example ... XD1-1108-221
XD1-1108-222
XD1-1108-225
Example ... BH-2184-000
( l = 20mm)
4
... 1 ...