Lanmit Image Correction - Canon CXDI-31 Service Manual

4.3.2. LANMIT Image Correction

(1) Purpose
Image data is input to the control PC's hard disk, and software calibration is performed to
correct the inherent image characteristics of the LANMIT.
(2) Notes
1) This adjustment must be performed during installation, when replacing the imaging unit
(sensor) or the control PC (hard disk), or when the device combination is changed.
2) This adjustment is performed to correct the inherent image characteristics of the
LANMIT. Note that the image data must be entered for each imaging unit that is
connected.
3) This adjustment can be performed from only the control PC. When only the control PC
is started up, a "Sensor Detect Error (-5101)" message is displayed when you open the
CXDI application, but you may ignore this message and proceed with the procedure.
(3) Input of image data file
1) Take off the left-side cover of the control PC.
2) Control the keyboard and mouse to the control PC.
3) Turn on the operation unit, and then turn on the control PC and start up Windows NT.
4) Insert the "Sensor DEF Data" disk supplied with the imaging unit into the floppy disk
drive of the control PC.
5) Open Windows NT Explorer from the Windows NT desktop.
Start Programs Windows NT Explorer
6) Open"3½Floppy (A:)" and find the "*******.dp" file. Copy this file to the "Ccr" folder
in the D drive.
7) After copying, close Windows NT Explorer, and then remove the "Sensor DEF data"
disk from the floppy disk drive.
8) Exit Windows NT, and turn off the power of all equipment.
2 Installation Manual
- 22 -