Canon CXDI-31 Service Manual page 85

(13) -a min_density
-a min_density
Minimum density (Dx100)
Meaning * This parameter is used in the DICOM Basic Film Box (2010, 0120).
* This parameter designates the density of the digital value for 4095 (0 for
reverse display) of the CXDI transfer data image pixels. (In the CXDI, 4095
indicates white.)
* This parameter is not transferred in many cases since the minimum density
cannot be increased in most printers.
Description If this parameter is not designated, it is not transferred over DICOM. In this
case, the printer default values are used. When this parameter is not transferred,
problems can occur since unsuitable default values may be used.
(14) -B border_density
-B border_density
Border density (Dx100) (BLACK/WHITE/D x 100)
Meaning * This parameter is used in the DICOM Basic Film Box (2010, 0100).
* This parameter determines the area density around the image on the film.
Description If this parameter is not designated, it is not transferred over DICOM. In this
case, the printer default values are used.
(15) -G empty_image_density
-G empty_image_density
Empty image density (BLACK/WHITE/D x 100)
Meaning * This parameter is used in the DICOM Basic Film Box (2010, 0110).
This parameter designates the density of the empty image area during multi-
formatting.
Description If this parameter is not designated, it is not transferred over DICOM. In this
case, the printer default values are used.
(16) -T trim
-T trim
Trimming (NO/YES)
Meaning * This parameter is used in the DICOM Basic Film Box (2010, 0140).
* This parameter adds lines around the image.
* The CXDI is normally adjusted so that the trimming does not appear.
Description If this parameter is not designated, it is not transferred over DICOM. In this
case, the printer default values are used.
* For example, the default value for this parameter in Agfa printers is YES.
Therefore, the NO option needs to be specifically designated if it is desired.
(17) -P polarity
-P polarity
Polarity (NORMAL/REVERSE)
Meaning * This parameter is used in the DICOM Basic Image Box (2020, 0020).
* Reverse image density
Description If this parameter is not designated, it is not transferred over DICOM. In this
case, the printer default values are used.
2 Installation Manual
- 59 -