Backing Up When Installing - Canon CXDI-31 Service Manual

4.3.15. Backing Up When Installing

(1) Purpose
The necessary files should be backed up so that the exposure position and other parameters
can be returned to the status immediately after setup when reinstalling the CXDI application.
(2) Necessary items
1) Laptop PC (OS: Windows95, 98 or NT)
*1 When using Windows NT, separate access settings must be made.
*2 The laptop PC should have a network card and driver installed, and should allow
network connections using TCP/IP.
*3 The backed-up files are approximately 30 MB in size, so secure empty hard disk
capacity of about 50 MB to ensure sufficient margin.
2) 10BASE-T cross cable or straight cable
* This is used for a 1-to-1 connection between the control PC and the laptop PC.
When using a straight cable, the separate tool HAB is necessary.
(3) Notes
1) Before performing backup, delete any exposure mode keys and image data exposed for
tests.
Deleting image data: Refer to the "Deleting Data" item.
Deleting exposure mode keys: Refer to the CXDI Series Operation Manual.
2) Backup should be performed immediately before handing over the product to the
customer only for new installations.
3) The backup described in this section is only a temporary measure. If the data is stored on
the laptop PC's hard disk, the data may be lost or other trouble may occur.
Storage on high capacity media (MO, Jaz, Zip, CD-R, etc.) or other measures should be
taken at the customer's responsibility.
4) Backup is performed using a 1-to-1 connection between the control PC and the laptop PC.
Therefore, when the system is connected to a network inside the hospital, it should be
disconnected from this network before starting the backup work.
2 Installation Manual
- 93 -