Special Tools; Special Tools; Hydraulic Pressure Test Kit; Hydraulic Tester - Pressure And Flow - Toro Greensmaster 3200 Service Manual

Special Tools

Order these tools from your Toro Distributor. Some tools
may also be available from a local supplier.

Hydraulic Pressure Test Kit

Use to take various pressure readings for diagnostic
tests. Quick disconnect fittings provided attach directly
to mating fittings on machine test ports without tools. A
high pressure hose is provided for remote readings.
Contains one each, 1000, 5000 and 10000 PSI gauges.
Use gauges as recommended in Testing section of this
chapter.
Hydraulic Tester – Pressure and Flow
This tester requires O–ring face seal (ORFS) adapter fit-
tings for use on this machine.
1. INLET HOSE: Hose connected from the system cir-
cuit to the inlet side of the hydraulic tester.
2. LOAD VALVE: A simulated working load is created
in the circuit by turning the valve to restrict flow.
3. LOW PRESSURE GAUGE: Low range gauge to
provide accurate reading at low pressure, 0 to 1000 PSI.
Hydraulic System
Figure 9
A protector valve cuts out when pressure is about to
exceed the normal range for the gauge. The cutout
pressure is adjustable.
4. HIGH PRESSURE GAUGE: High range gauge
which accommodates pressures beyond the capacity of
the low pressure gauge, 0 to 5,000 PSI.
5. FLOW METER: This meter measures actual oil flow
in the operating circuit with a gauge rated at 15 GPM.
6. OUTLET HOSE: A hose from the outlet side of the
hydraulic tester connects to the hydraulic system circuit.
Rev. C
Page 5 – 16
Figure 8
Greensmaster 3200/3200–D