Cleaning Radiator And Screen; Changing Engine Oil And Filter - Toro Greensmaster 3200 Service Manual

Cleaning Radiator and Screen

Keep radiator screen and radiator clean to prevent the
cooling system from overheating. Check and clean both
the screen and radiator daily. If necessary, clean any de-
bris off these parts hourly. Clean these components
more frequently in dusty and/or dirty conditions.
1. Release latches and remove radiator screen from
the support.
2. Remove fan shroud to access radiator corners.
Use eye protection such as goggles
when using compressed air
IMPORTANT: Air pressure should not exceed 40 psi
(2.8 bar) because damage to the radiator fins may
result.
3. Working from fan side of radiator, blow out the radia-
tor with compressed air.
4. Clean screen. Reinstall fan shroud and screen to
the radiator support. Secure latches.

Changing Engine Oil and Filter

Change oil and filter initially after the first 8 hours of op-
eration, thereafter change oil every 50 hours and filter
every 100 hours.
1. Remove drain plug and let oil flow into drain pan.
When oil stops, install drain plug.
2. Remove oil filter.
3. Apply a light coat of clean oil to the new filter gasket.
4. Screw filter on by hand until gasket contacts filter
adapter, then tighten 1/2 to 3/4 turn further. Do not
overtighten.
5. Add oil to crankcase, (see Check Engine Oil).
6. Dispose of oil properly.
Perkins Diesel Engine
CAUTION
1. Screen
1
1. Radiator
2
1
1. Drain plug
Page 4 – 14
2
Figure 19
2. Latches
Figure 20
2. Radiator support
Figure 21
2. Oil filter
Greensmaster 3200–D
1
2