Attitude Adjustment - Toro Greensmaster 3200 Service Manual

Attitude Adjustment

Note: There are four positions for the front roller
brackets. A more aggressive setting will increase grass
removal and provide a cleaner cut, but may cause in-
creased scalping and marking (Fig. 16).
Position 1: Least aggressive; used for very soft
and tender turf or the highest height–of–cut.
Position 2: Standard position; used for most
conditions.
Position 3: More aggressive; used on firm turf.
Position 4: Most aggressive; used only on very
firm greens or at the lowest height–of–cut.
Note: The top of the right front bracket is secured to
the frame with an eccentric bolt, while the left front
bracket is secured with a shoulder bolt (Fig. 17).
1. If the cutting unit is not already removed from the
machine,
A. Park machine on a clean and level surface, low-
er cutting units, stop engine, engage parking brake,
and remove key from the ignition switch.
B. Remove reel motor from the cutting unit and cut-
ting unit from lift arm (see Cutting Unit Removal and
Installation).
2. Remove lock nuts from the eccentric (shoulder) bolt
and carriage bolt securing both front brackets.
3. Remove eccentric (shoulder) bolt and carriage bolt
from both front brackets and the side plates.
4. Position both front brackets as follows:
Note: The top side plate hole and top bracket hole
should yield Position 2 (standard setting).
A. Insert eccentric bolt (shoulder bolt) through one
of the two positions in the figure 8 hole in the frame
and one of the top holes of the front bracket (Fig. 17)
so the point on the bracket is at the desired position
number on the decal (Fig. 16).
B. Screw lock nut onto the eccentric bolt (shoulder
bolt).
C. Insert carriage screw through the bottom hole of
the frame and front bracket. Secure carriage screw
and eccentric bolt (shoulder bolt) with lock nuts.
5. Level front roller to the reel (see Leveling Front Roll-
er to Reel).
Cutting Units
1
1. Point
4
1
1. Front bracket
2. Eccentric (shoulder) bolt
3. Lock nut
Page 8 – 14
2
Figure 16
2. Decal
3
5
Figure 17
4. Lock nut
5. Carriage screw
Greensmaster 3200/3200–D
2