Toro Greensmaster 3200 Service Manual page 40

15. Loosen cable clamp and remove choke cable from
the clamp. Disconnect choke link from the choke lever
(Fig. 28)
16. Disconnect the following electrical connections
(Fig. 18):
A. The black (negative) battery cable (36) and
black wire harness ground (37) from below the oil fil-
ter.
B. The red (positive) battery cable and red wires
and connector on the starter solenoid.
C. Red/violet and red wires and connector on the
starter solenoid.
D. The blue and green wires and connector to the
speed sensor near the water pump.
E. The red/white wire and connector for the fuel
shut off solenoid near on the main harness near the
ECU.
F. The blue wire on the water temperature sender
(3).
G. The green/blue wire on the oil pressure switch.
H. The black and white/black wires and connector
for the fuel pump (39).
I. The connector from the electric governor. Re-
move R–clamps securing the main electrical har-
ness to the frame (Fig. 29).
IMPORTANT: Label wires on the ignition coils for
assembly purposes.
J. The yellow/blue and yellow/red wires on the igni-
tion coils
K. The green, green/blue, and red/blue wires and
connector to the alternator. The red wire and con-
nector to the alternator.
17. Remove both cap screws securing the ECU to the
frame. Position ECU away from the engine.
18. Remove both whiz screws (48) securing the dust
shield (47) to the front engine mount (13) (Fig. 18).
19. Remove alternator (51) and fan adapter (24) from
the engine for better clearance (Fig. 18).
20. Remove three whiz nuts (20), plate washers (21),
and cap screws (19) securing the front engine mount
(13) and rear engine mount (11) to the rubber mounts
(18) (Fig. 18).
21. Disconnect fuel hose (17) from the carburetor on the
engine (1) (Fig. 18).
Vanguard 3/LC Gasoline Engine
One person should operate the chain fall
or hoist while the other person guides the
engine out of the frame.
22. Remove engine from the frame.
A. Connect a hoist or chain fall to the engine
mounts.
IMPORTANT: Make sure not to damage the engine,
fuel and hydraulic lines, electrical harness, or other
parts while removing the engine.
B. Slowly remove the engine and mounts from the
machine.
1
2
1. Cable clamp
2. Choke cable
1. Connector (governor)
2. R–clamps
Page 3 – 22
CAUTION
4
3
Figure 28
3. Choke link
4. Choke lever
2
Figure 29
3. Main electrical harness
Greensmaster 3200
1
3