Bedknife Adjuster Service (Single Point Adjust Cutting Units) - Toro Greensmaster 3200 Service Manual

Bedknife Adjuster Service (Single Point Adjust Cutting Unit)
Removal
1. Position machine on a clean and level surface, low-
er cutting units, stop engine, engage parking brake, and
remove key from the ignition switch.
2. Remove both pivot screws (14) from the pivot hous-
ing (13). Replace plastic bushings (16) if worn or dam-
aged (Fig. 25).
3. Unscrew adjustor (20) from the bedbar pivot (34)
(Fig. 25).
Disassembly (Fig. 39)
1. Remove compression spring, adjustor, thrust wash-
ers, and nylon thrust washers from the pivot housing.
2. If the spring arm is damaged, remove it from the piv-
ot housing by removing both hex head screws.
Assembly (Fig. 39)
1. If the spring arm was removed, apply loctite 242 or
equivalent to the threads of both hex head screws. Se-
cure spring arm to the pivot housing with both hex head
screws.
2. Place thrust washer, new nylon thrust washer, and
second thrust washer onto the adjustor. Insert adjustor
through the pivot housing.
3. Slide nylon thrust washer onto adjustor. Slide thrust
washer onto adjustor and over nylon washer. Slide com-
pression onto adjustor.
Installation
1. Place antiseize lubricant onto the threads of the ad-
justor (Fig. 39).
2. Screw adjustor (20) into bedbar pivot (34) enough
to align holes of the frame bracket and pivot housing
(13) (Fig. 25).
3. Place pivot screws (14) through bushings (16) in the
frame bracket and into the pivot housing (13). Tighten
screws into the pivot housing (Fig. 25).
4. Adjust bedbar to reel (see Bedknife to Reel Adjust-
ment).
Greensmaster 3200/3200–D
3
6
3
1. Compression spring
2. Adjustor
3. Thrust washer
4. Nylon thrust washer
Page 8 – 31
2
4
4
1
Figure 39
5. Spring arm
6. Pivot housing
7. Hex head screw
Cutting Units
7
5