Front Wheel And Brake - Toro Greensmaster 3200 Service Manual

Front Wheel and Brake

22
1
2
RIGHT
FRONT
1. Lug nut
2. Tire
3. Brake drum
Removal (Fig. 7)
1. Park machine on a level surface. Make sure engine
is off. Make sure brake is in the OFF position.
2. Lift front wheel off the ground using a jack, and place
blocks beneath the frame under the hydraulic wheel mo-
tor (10). Block front and rear of other wheels.
3. Remove lug nuts (1) and tire (2) and rim (23). Re-
move lock nut (14) from hydraulic wheel motor (10)
shaft.
IMPORTANT: DO NOT hit wheel hub (24) with a ham-
mer during removal or installation. Hammering may
cause damage to the hydraulic wheel motor (10).
Wheels and Brakes
23
14
24
3
4
25
4
16
26
Figure 7
Page 7 – 10
27
20
28
5
6
19
29
13
18
12
21
15
4. Use a puller to remove the wheel hub (24) and brake
drum (3). Remove the key (5) from the hydraulic wheel
motor (10) shaft.
5. Remove return springs (4) from brake shoes (27).
Remove brake shoes from backing plate (28).
6. Remove retaining clip (29) and brake cam (26) from
the brake lever (13) and backing plate (28).
7. Remove four hex head screws (16), lock nuts (19),
and backing plate (28) from the brake bracket (6).
8. Parts should be clean and free of rust. Inspect brake
shoe (27) and brake drum (3) contact surfaces for ex-
cessive wear. Replace any worn or damaged parts.
7
8
30
9
31
10
11
17
Greensmaster 3200/3200–D