Toro Greensmaster 3200 Service Manual page 171

Removing Hydraulic Reservoir (Fig. 85)
1. Before removing any parts from the hydraulic sys-
tem, park machine on a level surface, set brake, lower
cutting units, and stop engine.
CAUTION
Operate all hydraulic controls to relieve sys-
tem pressure and avoid injury from pressur-
ized hydraulic oil. Controls must be oper-
ated with the ignition switch in RUN and the
engine OFF. Return ignition switch to OFF
when pressure has been relieved. Remove
key from the ignition switch.
2. Clean oil filter assembly (8) and hose connection,
hydraulic tank (6) and hose connections, and pump inlet
hose connections at the hydrostat.
3. Place a suitable container under the hydrostat to
collect hydraulic oil. Clamp pump inlet hose to prevent
drainage. Remove pump inlet hose from hydrostat and
direct to container. Release clamp from hose (Fig. 86).
4. Disconnect hose assembly from the hydraulic fitting
welded to the reel motor case drain tube located below
the right side of the frame. Allow hose to drain to a suit-
able container (Fig. 87).
5. Disconnect formed hose (21) from hydraulic barb fit-
ting (9). Allow hose to drain to a suitable container.
6. Remove cap screw and flat washer securing the
console shroud to the hydraulic tank. Remove both cap
screws and flat washers securing the console shroud to
the lower panel (Fig. 88).
7. Remove three hex head screws and flat washers
securing the mounting plate (11) to the frame. Two
screws are located on the top of the plate at the front cor-
ners of the fuel tank. The third screw is in front of the cas-
tor fork and below the plate.
8. Tilt mounting plate (11) up by lifting at the rear of the
machine. Prop up plate securely. Remove four cap
screws (16) and flat washers (12) securing the hydraulic
tank (6) to the mounting plate.
9. Remove hydraulic tank (6) from the mounting plate
(11).
10. Hoses (31 and 32), hydraulic fittings (9,1, and 2),
and O–rings (29, 27, and 25) may be removed from the
hydraulic tank (6).
Greensmaster 3200/3200–D
PUMP INLET HOSE
1. Hose assembly
4
3
2
1. Cap screw
2. Cap screw
3. Flat washer
Page 5 – 99
Figure 86
1
WELDED
FITTING
2
Figure 87
2. Case drain tube
1
3
6
Figure 88
4. Console shroud
5. Hydraulic tank
6. Lower panel
Hydraulic System
5