Steering Cylinder - Toro Greensmaster 3200 Service Manual

Steering Cylinder

CYLINDER
ASSEMBLY
2
1
10
1. Hose assembly
2. O–ring
3. Hydraulic fitting
4. Jam nut
5. Ball joint
Removal (Fig. 84)
1. Before removing any parts from the hydraulic sys-
tem, park machine on a level surface, set brake, lower
cutting units, and stop engine.
Operate all hydraulic controls to relieve sys-
tem pressure and avoid injury from pressur-
ized hydraulic oil. Controls must be oper-
ated with the ignition switch in RUN and the
engine OFF. Return ignition switch to OFF
when pressure has been relieved. Remove
key from the ignition switch.
Hydraulic System
4
5
2
3
9
7
8
13
6. Frame
7. Steering cylinder
8. Retaining ring
9. O–ring
10. Wheel
CAUTION
6
11
8
3
5
12
Figure 84
2. Clean steering cylinder assembly, hydraulic fittings,
and hose assembly connections. Label all hose connec-
tions for reassembly purposes
3. Remove hose assemblies and O–rings from hy-
draulic fittings. Allow hoses to drain into a suitable con-
tainer. Put caps or plugs on any hose connections left
open or exposed.
Page 5 – 96
14
4
11. Lock nut
12. Bolt
13. Spacer
14. Castor fork
Greensmaster 3200/3200–D
12