Front Roller Removal And Installation - Toro Greensmaster 3200 Service Manual

Front Roller Removal and Installation

Removal
1. Position machine on a clean and level surface, low-
er cutting units, stop engine, engage parking brake, and
remove key from the ignition switch.
Note: The front roller can be removed with the cutting
unit either attached to the lift arm or removed from the
lift arm. Determine your maintenance needs.
2. If removing the cutting unit, remove reel motor from
the cutting unit and the cutting unit from lift arm (see Cut-
ting Unit Removal and Installation). Place cutting unit on
a level working surface.
3. If keeping the cutting unit on the lift arm, remove
both shoulder bolts securing the front brackets to the
pull frame (Fig. 26).
4. Remove cap screws securing the roller shafts to
each front bracket (Fig. 27).
Note: The right front bracket is secured to the frame
with an eccentric bolt and carriage screw, while the left
front bracket is secured with a shoulder bolt and car-
riage screw (Fig. 27).
5. On either end of the roller, remove eccentric bolt
(shoulder bolt), carriage screw, and lock nuts securing
the front bracket to the frame (Fig. 27).
6. Remove the front brackets and roller from the cut-
ting unit. Remove the front brackets from the roller shaft
(Fig. 27).
7. If the front roller position is to be changed, the re-
maining front bracket may be removed from the frame
using step 5.
Installation
1. Place cutting unit on a level working surface.
Note: The front roller brackets have four positions. A
more aggressive setting will increase grass removal and
provide a cleaner cut, but may cause increased scalping
and marking (Fig. 28).
Position 1: Least aggressive; used for very soft
and tender turf or the highest height–of–cut.
Position 2: Standard position; used for most
conditions.
Position 3: More aggressive; used on firm turf.
Position 4: Most aggressive; used only on very
firm greens or at the lowest height–of–Cut.
Greensmaster 3200/3200–D
1. Shoulder bolt
2. Front bracket
6
7
1
3
2
1. Cap screw
2. Roller
3. Front bracket
4. Eccentric (shoulder) bolt
Page 8 – 21
2
1
3
Figure 26
3. Pull frame
4
5
Figure 27
5. Carriage screw
6. Lock nut
7. Lock nut
Figure 28
Cutting Units