Wiehle Rear Roller Bearing Replacement - Toro Greensmaster 3200 Service Manual

Wiehle Rear Roller Bearing Replacement

Note: This procedure is for the Wiehle Rear Roller Kit
(Model 04488) only.
Remove Bearings
Note: Use the bearing replacement tool kit to remove
the roller bearings (see Special Tools).
Note: It is recommended to replace bearings at both
ends of the roller after bearing failure.
1. If a hole is not on the bearing shaft, use drill bushing
(supplied with bearing replacement kit) to drill a hole in
the bearing shaft.
2. Remove roller bearing with bearing puller.
3. Clean roller bearing cavity and remove any rust with
a crocus cloth.
4. Repeat above steps for the other roller bearing.
Install New Bearings
1. Make sure roller bearing cavity is clean and free of
dirt. Apply No. 2 multipurpose lithium based grease to
the roller bearing.
2. Press roller bearing into roller so that the outside
surface of the bearing is flush with the end of the roller.
3. Grease the bearing with No. 2 multipurpose lithium
based grease until grease appears at the seal of the
bearing.
4. Repeat above steps for the other roller bearing.
Greensmaster 3200/3200–D
2
1. Roller bearing
2. Roller (Wiehle)
Page 8 – 25
1
3
BEARING AND ROLLER
SURFACE MUST BE FLUSH
Figure 30
3. Grease fitting
Cutting Units