Toro Greensmaster 3200 Service Manual page 256

2. If both front brackets were removed, position brack-
et as follows (Fig. 27):
A. Insert eccentric bolt (shoulder bolt) through the
top hole on the frame and one of the top holes of the
front bracket so the point on the bracket is at the de-
sired position number on the decal (Fig. 28).
B. Screw lock nut onto the eccentric bolt (shoulder
bolt) to hold front bracket in place.
C. Insert carriage screw through the bottom hole of
the frame and front bracket. Secure screw and ec-
centric bolt (shoulder bolt) with lock nuts.
Cutting Units
3. Place roller shaft into the front bracket. Slide second
front bracket on the other end of roller. Secure bracket
as in step 2. (Fig. 27).
4. Apply Loctite 242 or equivalent to the cap screw
threads. Center roller in the front brackets and secure
into place with the cap screws (Fig. 27).
5. Level front roller to the reel (see Leveling Front Roll-
er to Reel and Attitude Setting).
6. If the cutting unit was kept on the lift arm, attach the
front brackets to the pull frame by securing with both
shoulder bolts (Fig. 26).
Page 8 – 22 Greensmaster 3200/3200–D