Toro Greensmaster 3200 Service Manual page 38

8. Remove fuel tank and hydraulic reservoir as fol-
lows:
A. Remove three cap screws (6) and two flat wash-
ers (14) securing tank mounting plate (13) to the
support bracket (27) and frame (Fig. 17).
B. Disconnect expansion tank hose (25) from the
radiator elbow (27) (Fig. 16).
C. Disconnect hydraulic hose from welded fitting on
the tube leading into rear bulkhead (Fig. 21).
D. If the oil cooler is not installed, disconnect hy-
draulic hose from the hydraulic oil filter (Fig. 22).
E. Make sure cable ties and hose clamps securing
hoses to the frame and supports are removed.
F. Disconnect leak detector harness.
G. Lift mounting plate and tanks from the machine.
9. Remove air cleaner as follows (Fig. 23):
A. Disconnect air cleaner hose (40) from the carbu-
retor adapter (34) (Fig. 18).
B. Disconnect hose leading to the radiator from the
cleaner.
C. Disconnect air cleaner bracket from the pump
mount. Remove air cleaner and bracket from the
machine.
The muffler and muffler tube may be hot.
To avoid possible burns, allow the ex-
haust system to cool before working on
the muffler and muffler tube.
10. Remove muffler as follows (Fig. 24):
A. Remove four cap screws and lock washers se-
curing the exhaust plate to the engine exhaust man-
ifold.
B. Remove muffler shield from the muffler and
pump plate by removing four cap screws.
C. Remove two cap screws securing the muffler to
the pump plate. Remove muffler from the machine.
11. Remove fuel filter (39) to the front engine mount (13)
(Fig. 18).
Vanguard 3/LC Gasoline Engine
CAUTION
2
1. Hydraulic hose
8
5
4
1. Hose (to carburetor)
2. Hose clamp
3. Air cleaner
4. Hose (to radiator)
4
7
1. Cap screw
2. Lock washer
3. Exhaust plate
4. Muffler shield
Page 3 – 20
Figure 22
2. Hydraulic oil filter
6
2
2
Figure 23
5. Air cleaner bracket
6. Pump plate
7. Cap screw
8. Lock nut
7
5
3
Figure 24
5. Muffler
6. Pump plate
7. Cap screw
Greensmaster 3200
1
7
1
3
1
2
7
6